PBC Linear Blog - All about Industrial Linear Motion Components

An Innovative 3D Printing Solution Provider

An Innovative 3D Printing Solution Provider

3D Platform has been one the innovators in the large format, open market category, has a wider installed base than anyone else in…

Large 3D Printer, Electronics, and Design

Large 3D Printer, Electronics, and Design

Industry need was the primary driver in developing a large format printer. Engineers needed a printer that was capable of producing an…

Mechatronics In Large Format 3D Printing

Mechatronics In Large Format 3D Printing

One of the great things about being in research and development is reaching a goal only to see another goal post in the distance. This…

Creating a Voronoi Model

Creating a Voronoi Model

Voronoi models produce some fascinating models and cut down on material consumption. In most cases, Voronoi structures are printed without… 

3D Printer Filament Sensor Solution

3D Printer Filament Sensor Solution

A filament sensor tells a printer when it runs out of filament. A filament sensor bracket needs to be able to hold the filament sensor,...

3D Printing Tech Tips: Printing with Metal Inserts

3D Printing Tech Tips: Printing with Metal Inserts

The complexity of a part sometimes requires us to split it into components before 3D printing. Several techniques are used to fasten these…

3D Printing Tech Tips: Minimum Layer Cool Down

3D Printing Tech Tips: Minimum Layer Cool Down

Insufficient cooling of your 3D printed part might leave the print looking melted and often misaligned. Cooling can be a major issue especially…

3D Printing Tech Tips: Point Head Crashing

3D Printing Tech Tips: Point Head Crashing

Recently we’ve had a print failure where the print head dropped down in the middle of a print, crashed into the part and broke both...

Printing Overhangs Beyond 45 Degrees

Printing Overhangs Beyond 45 Degrees

The general rule of printing slopes/overhangs is that they shouldn’t exceed 45-degrees. The whole idea behind the 45-degree rule… 

3D Printing Tech Tips: Recover a Failed Print

3D Printing Tech Tips: Recover a Failed Print

Let’s say you were printing the Eiffel tower. The part failed at a ‘Z’ height of 29.55 mm. The following solutions can help you recover...

Building Blocks of Success: Test Chip

Building Blocks of Success: Test Chip

Use this test chip tutorial video to help quickly determine if the flow rate is set properly on your large format 3D printer. It is...

Building Blocks of Success: Thin Wall Box

Building Blocks of Success: Thin Wall Box

Successfully set your extruder flow rate. Use this thin wall box tutorial video to help quickly determine if the flow rate is set properly on…